Serenity - May 12 2007

00512151.jpg
00512151.jpg

00512152.jpg
00512152.jpg

Mould separation line

00512153.jpg
00512153.jpg

00512154.jpg
00512154.jpg

00512155.jpg
00512155.jpg

00512156.jpg
00512156.jpg

00512157.jpg
00512157.jpg

00512158.jpg
00512158.jpg

00512159.jpg
00512159.jpg

00512160.jpg
00512160.jpg

does that look gorgeous or what?

00512161.jpg
00512161.jpg

The detail is all there

00512162.jpg
00512162.jpg

00512163.jpg
00512163.jpg

00512164.jpg
00512164.jpg

00512165.jpg
00512165.jpg

00512166.jpg
00512166.jpg

00512167.jpg
00512167.jpg

00512168.jpg
00512168.jpg

00512169.jpg
00512169.jpg

The rear which is not seen but included to show where the resin was poured in, the center where I had the threaded rod and the 2 side mounting tabs

00512170.jpg
00512170.jpg

Underside recessed area that saved loads of resin

00512171.jpg
00512171.jpg

00512172.jpg
00512172.jpg

The following are photos showing some of the mould separation lines

00512173.jpg
00512173.jpg

00512174.jpg
00512174.jpg

00512175.jpg
00512175.jpg

00512176.jpg
00512176.jpg

00512177.jpg
00512177.jpg

I have to say that the casting is amazing. All the vents are there and detail is sharp. To say I am happy is an understatement. I am so close to a finished model I can taste it


Page:   1  2  3  4  5  6 

 

[ Prev ]      [ Next ]