Serenity - May 20 2007
To solve the step problem with the cargo and main body I decided to take a chunk out of the engine section. I also could have added a thin sheet of styrene or left it as is but this seemed to be the easier choice for me
I was thinking of making everything disassemble if needed. I might still do that but for now to keep that mentality of forging ahead I have glued the swirly thing (yoke?) (horse shoe?) to the main body. I have used the holes I had before for the 1/4" -20 threaded rod and reinserted a bolt to allow me to assemble and disassemble the rear engine section. This also lets me take apart the cargo area but I am not sure if I like that assembly method. This would allow access to the cargo area where I can put in some electrics for engine lighting. Unfortunatley my 5 minute epoxy took a lot longer then 5 minutes to set up
While waiting I start to clean up the other 2 set of castings
