Serenity - May 12 2007
the same basically applies to both engines
So the engines look rough. 2 saving graces. One is the intake is clean. Two is a lot of it is hidden by this shield that goes around the body. A bit disappointing as the shape doesn't look too hard at all.
I could have cast this in with the main body but though why not make it a separate item. It open up possibilities for later
The detail looks good
An excellent casting. My caster says that he can cast this in clear. So this makes the possibility of a cockpit being included that much easier.
Underside
And finally the main body. The part I was worried about. Worried that it was an impossible thing to cast.
Well it is late and I am getting quite tired so for now I will le the photos do most of the talking
This is one of the first casting so the mould did separate slightly and the nose is a bit bigger then it should be
Of the two top ribs the left one either broke off or was not cast properly. An easy problem to fix
Not sure what happened here as one of the openings looks filled in. Again not a major problem
