Serenity - April 10 2007 |
More castings. I have enough landing pads to satisfy my set of 10 but am continuing making them for later |
Removing the mould walls |
The part separates from the base |
To remove the master I cut into the mould. I only cut as much until I can get the master out. This is then my mould. A bit quicker then a 2 part mould but it produces other problems. |
I can't wait so I start casting using Alumilite |
While that cures I rebuild the box to make a second mould. Why not |
And here we are again in the vacuum chamber to boil away as many air bubbles as possible |
First pull and the bottom part of the mould is a massive air bubble. This casting I just poured and squeezed the mould to try and get the air bubbles out. It looks like I will have ot take a more aggressive approach. |