Serenity - March 24 2007 |
Since I need landing pads I start casting. And with no more Alumilite I use the new stuff. It is supposed to have a tan colour when cured and it is supposed to kick in 5 minutes. So I follow instructions and shake the clear part of the 2 part resin and pour equal amounts into a cup and mix and pour |
Um 11 minutes later and it is still clear. I decide to demould the other landing pad. |
Demould the jig mould |
Um 34 minutes and still clear. I have a bad feeling about this |
I pour some of the white resin. Shuttles and solar panels |
A couple of hours later and there is some reaction |
Well it finally does cure after several hours. I think I did not mix the original container enough. I will know next time and thank goodness it cured |