Serenity - Feb 25 2007 |
Touched up base |
Close up |
Filing the top chips the sides |
Trying to remove the sides then chips the base. I can't seem to win. Later I will try and touch up the base and hope it will look OK |
Pull the mould for the shuttle wings and the landing pad |
Yeah well the mould for the shuttle body cured OK However my use of mould release compound was not as successful as the 2 sides are very stuck together. It takes me over half an hour to finally be able to pry the sides apart |
The now mould |
A first pour. However I am too anxious and pour before I cut a gate to allow air bubbles to escape. It does look OK |
The first body and wings. A bit anxious pulling them as the resin is still slightly flexible |
A coat of Alclad II Aluminum Plate is sprayed |
It looks good so far |