Serenity - Jan 20 2007 |
Using the existing moulds I try and start poring with the resin I have. It has a 5 minute pot life so in theory I should have loads of time to get as many bubbles out as I can. This is the engine exhaust |
This is the front sensor arrays |
This is the engine turkey feathers |
Disaster as the resin is brittle and the engine exhaust parts breaks up as I try and remove it from the mould |
Sensor arrays look good |
Not bad but demould time is half a day. |
More disaster as the turkey feather also breaks |
Close up of break |
The other half |
Attempts to repair it are unsuccessful |
So I pour again and hope |