 012301.jpg
There be squares. Surprisingly it was not easy to get the squares to look right. I made a bunch of them
and chose the best 4 looking ones
|
 012302.jpg
Next I tried to make the rings that go on top of the squares. I first punched the smaller hole and
then tried to line it up in the punch to punc out the ring. I first tried with a larger inside hole then a smaller
hole but no matter what I tried I think the styrene would deform and punch out an offset ring
|
 012303.jpg
Thinking it was the styrene I tried using aluminum sheet but this was not any better so I gave up on this for now
|
 012304.jpg
Backto the bottom and attmpets to glue on thes quares. Here I am using masking tape as guide lines
|
 012305.jpg
A couple of the squares have been added on. Some minor tweaking was needed to get them to look right
|
 012306.jpg
All 4 are done
|