Serenity - Dec 14 2006
One of the detail pieces was knocked off while hollowing out the inside
The piece was replaced and then on both sides I did a bit of puttying to fill in the tiny gap that was there. Don't want any rubber mould material seeping inside
Sometimes the bit get away from me and does some damage
Small part of the shuttle recess is damaged when the bit went through. It will have to be fixed.
Test fitting to see if the styrene sheet I am planning to use as the bottom will fit
Areas marked where I need to grind away
Also the other side
After much grinding the sheet fits in
This is the depth of the sheet
I get greedy and want to make it even deeper so I start grinding away again
A better view of the amount I am taking out
After much messiness the sheet is deeper