Serenity - Nov 20 2006 |
Back to the photo etching |
I was not satisfied with the solar panels and wanted to see if I could make them better. The main purpose of the new PE sheet was the small detail for the shuttle. Mainly the door. This close up (although fuzzy) shows the parts repeated multiple times |
The toner transfer paper has been bonded to the brass sheet and then laid over with the green paper |
Here it is after the green paper has been taken off |
However I guess I am still not good at this green stuff as the results suck |
Not good and I didn't make a second sheet so progress in this area has halted |
So back to making the panel by hand |
More filling but using CA glue and the panel getting there |
More CA glue filling and sanding. Accelerator speeds this process. |