Serenity - Nov 11 2006

011111.jpg
011111.jpg

The countdown and still little tings to do. The bottom of the ship is not completely sealed and needs to be if a mould has to be made of the RTV compound will seep into the model.

011112.jpg
011112.jpg

So a piece of sheet styrene is laced over the bottom. CA glue is used to seal the edges as best as I can. Then putty for the holes that the CA glue can not seal

011113.jpg
011113.jpg

I also notice that one of the surface detail is missing so I replace it with thin sheet styrene

011114.jpg
011114.jpg

The long threaded rod out the back is cut off as the entire length is not needed. The short stub is needed to locate teh rear section

011115.jpg
011115.jpg

Every thing is boxed up and ready to go