Serenity - October 3 2006
Back to using the photo copier at work I produce 3 sheets and I laminate on 3 brass sheets. I also decide to live dangerously and I use the green transfer paper on all of them. 2 of them worked and this one does not. What am I doing differently? I have a different laminator I got off ebay. Could it run hotter? I also used only the plastic cleaning pad and no cleaner
I also noticed when using the tank and bubble maker that the bubbles create quite turbulent water flow and this is seen in the results. What I did this time was face the etched side away from the bubbles. I am hoping the reduced turbulent flow will produce a less jagged results on the edges. Well the results look good so far. Again I stopped the etching process early for fear of over etching and the parts being undercut. I am 'appy