Serenity - October 1 2006

010011.jpg
010011.jpg

The side cargo bay panels. These panels were tight to the side of the cargo bay so I was a bit confusing on how to make them so tight with the mounts having to be so long so that they are effective. Then it occurred to me that I can put it in the recessed part of the side. The right blue mark is the original mount that I abandoned

010012.jpg
010012.jpg

Shazam. Panel installed. Too bad it is too low. Yeah of course you knew that and was just about to email me to tell me how I goofed up.

010013.jpg
010013.jpg

The back showing the short aluminum tube used as a mount. I used the aluminum tube and brass combo according to how I think things can be cast. Doh! I just thought of another method that might be better. No wait. Scratch that I don't think it would be better and it would be harder to control. Whew good thing I did go and change everything and then find out there are problems with the method I was thinking of.

010014.jpg
010014.jpg

Blah blah yadda yadda

010015.jpg
010015.jpg

Done.