Serenity - September 9 2006 |
The new brass part goes on |
A close up of some of the detail I was able to put on. This is the good side. The other side does not look so good and I didn't happen to take a photo of that. Darn |
Here are the new circles I made after realizing the other ones were too large. A quirk of the graphics program made them larger then I wanted. |
All cleaned up of the PE process using Lacquer thinner |
The parts ready to go on |
On the left are the new parts and on the right the old part. Not easy to see but there is a slight size difference. |