Serenity - September 7 2006

0090701.jpg
0090701.jpg

I wanted to see if I could get better results. I already tried once and the green transfer did not work too well so I cleaned it off and tried again. This time I sanded the brass slightly to hopefully make the toner stick better. However results were not great

0090702.jpg
0090702.jpg

Broken areas of the green transfer

0090703.jpg
0090703.jpg

The other piece

0090704.jpg
0090704.jpg

and the close up with teh problems

0090705.jpg
0090705.jpg

More problems

0090706.jpg
0090706.jpg

So I go back to the one I made the day before and how the circles

0090707.jpg
0090707.jpg

The three bottom pieces all cleaned up

0090708.jpg
0090708.jpg

They will be layered to create a 3D relief

0090709.jpg
0090709.jpg

All of the parts on top of each other

0090710.jpg
0090710.jpg

Close up of the detail

0090711.jpg
0090711.jpg

Beside the one layer existing part