Serenity - August 24 2006
Boxes done
Backsides filed down at an angle to allow easier placement in recessed area if the recess s not completely cleared out
Recessed area carved out using a Dremel tool
Box is glued in taking care to position it so that the inside lip is evenly distributed as much as possible
More glue is applied to make sure it is stuck in there solidly
This is the start process of the grinding using the Dremel tool and a thin grinding bit
More and more material is carved out
Once the dept is reached I use the Dremel tool to be as clean as possible. Then I go in with exact knives and files to clean it up more
Box glued into the newly carved recess
and puttying
The other side