Serenity - May 28 2006 |
One panel has been cut and shaped and test fitted to the rear section |
Close up showing the slight lip in the panel |
Top of the panel |
another view |
Panels 1 and 2 finished |
Panels 3 and 4 finished |
Now to start the smaller panels |
These panels I am vac forming out of sheet styrene because I want to light the rear engine and I think this thin styrene will do the job. I considered clear acetate but then I would have to give it a matte finish anyway. If I were to cast it I would have to make a new master with an inner and outer mould. This would be tricky but I can then control the inner wall thickness so the panel places would be thin. Will it work? I don't know since I am not there yet. The rest of the engine part will be primed with a grey primer to prevent light leakage. |