SERENITY - Feb 11 2006
A thin strip of pop can aluminum for the rear neck. I am taking this picture because I had to make this piece 3 times before I was happy with it. It looks simple doesn't it?
This is where the piece is supposed to go. Not trimmed to length yet
It took 3 tries before I finally centered the part. I pre rolled it to give it the curved shape
Another view. It sure was not my day to get it right the first time
template made of the side recessed areas
Longer view to show where it is on the model
Starting to cut sheet styrene
Cross pieces I felt best done with think styrene
Some preliminary trimming to shape