SERENITY - Jan 12 2006
Finally done (again)
Nice fit
The rear window before filing and sanding
After sanding
Now putty work
Here we go again. Fingers crossed
The resin was just poured so it is still liquid. You can tell because it is clear
Cured. You can tell because it is opaque. Well at this point the chemical reaction has kicked in and is not 100% cured so it is still a bit soft. A good time to do some quick trimming
Quickly trimmed
and now putty
Super small but these are engine detail parts. The exacto knife is to give you an idea of how small they are.
Close up and I will probably make a mould of this item and cast it.