SERENITY - Jan 11 2006
Instead of automotive putty to fill n the gaps as in the other frames I used 2 part resin since the gaps were very small and there was quite a bit of room behind the frame
Reverse angle of rear frame
Front frame. Yes a bit messy
Another angle
I decide to clean up as much as I can while the resin cures. Unfortunately I discover that the frame is not recessed enough at the top and the window will not sit deep enough. Not many options. I could leave it but it will look funny so I start to try and pull out the frame
Not an easy job as it ruins the frame
What a mess
At least I cleaned out the recessed area
This is all that survived of the frame. Unfortunately the top parts has been shaved too thin so this will have to be replaced
Starting again
This bites that I am doing it again
Starting the top (again). Tired now and need sleep so I stop here