SERENITY - Dec 16 2005 |
Ok finally done al the cutting. Then when I start to use the parts I find out I made extras. Great on my part but then it was extra work cutting the stuff out when I didn't need to |
The engine mating part now had the incorrect profile and I have to turn it down. This is before |
And after turned flat to accept the new parts |
Start of gluing the detail parts on |
This was relatively fast using CA glue |
Second layer was put on. This required a bit more work as each one had to be put on one at a time. The strip did not line up so i could not do multiples |