SERENTY - Dec 6 2005
Almost done
Done. Whew
Bottom almost ready for the new piece
I was making a mould for something else and instead f the 24 hours for the mould to harden it has been 4 days. After the first day I figured it was a bit cool in the basement so that may be slowing the curing time. I then out it in my spray booth and turned on the light. This normally warms the inside enough but I forgot that the cold air from outside would come down my exhaust hose so the inside was also cool. I then put it in the furnace room which I thought would be hot. It was warmer but not very warm so it was still not cured. Hopefully the RTV has not been permanently affected and will cure eventually. I will have to remember this when I make the mould for the engine detail piece.