SERENITY - Dec 2 2005
Started to chop into the rear section for the tail. Only one boo boo with the Dremel tool that I will have to fix
OK here is the tail popped in to show what it will look like. On the down side while looking at the tail piece I noticed that it is lopsided. F#%$% It will take quite a bit to fix it
So I went to pick up the brass plaque and it looks good. As I am walking away I noticed that Sean says Scan. I take it back and he manages to make the 'C' into an 'E'. It looks OK and it was too late to get the entire thing done again as I was meeting my friend tomorrow and didn't have time to get it redone. Later on while checking the names which were all fine (I hope) I noticed that the 'Serenity' was spelt 'Serenty'
Son of a... Well I figure I can later get a new small plaque with Serenity on it to cover the mistake.