SERENITY - Nov 4 2005 |
More filing |
After looking at the images again I see there are a few problems with the underside shaping |
I double check with this height gauge |
I try and match up the left and right sides |
Later on I discover that the flat surface I was using IS NOT FLAT. It flexes a bit and was giving me false readings. I lost quite bit of time trying to figure out what was wrong |
The underside with marking of where my problems are |
Incredibly this area is out. It maybe only a few mm but to the eye it is obvious when I mark it with lines. |
Finally from this view you can see the slight errors brought out by the lines drawn on the model |
Why do you look at things hundreds of times and it looks fine but looking at it from a different view you can obviously see the errors. I was tearing my hair out trying to figure out where it was off. It was only after I started drawing lines that I was able to spot the problem. |