SERENITY - Oct 31 2005

SERENITY - Oct 31 2005

103101.jpg

Argh looking again at references I notice this area is just not quite right so more filing

103102.jpg

Close up

103103.jpg

103104.jpg

And this area is also slightly off

103105.jpg

The other side

103106.jpg

Close up. The red lines is where I will make modifications

103107.jpg

I noticed this problem before but only after getting new references was I sure that this area was not right

Putty added

The other side

Close up

Initial rough carving

The other side

Getting there

Close up

Start the other side

Close up

Getting there

After close examination of the area it is too rough and so even more putty goes on. There was a slight indent that was not smooth and sanding could not fix so out comes the putty

103121.jpg

Same with the other side. A very slight minor indent but I can not help myself

It looks like there is competition. Well sort of. A fellow flan is working on a paper model. Actually there are 2 people working on a paper model. One guy has done the engines already and another is working on the 3D mesh which he will use to make his paper model.

Different medium but it does encourage me to get moving more on my model.

Looking at references again I see that there is slight errors in the neck area which I can not help but redo. ! Step forward and 2 steps back.