 082601.jpg The rear engine asting I did before was full of dents and stuff from the improper casting process so I wanted a cleaner one so here I am casting another one but this time I set up a little jig to hold the PVC part so I did not have to do it by hand. Then it turned out that when I mixed the resin I was too vigorous and madea lot of air bubbles that show up in the casting. F##^#^%#@ |
 082602.jpg To mould the engine section I was going to have problems pullng the part out of the mould due ot the engine mounts. To make it easier I have glued in a little flange that will help out (hopefuly) |