Revell 1:24 Ferrari 458

45821.jpg
45821.jpg

45822.jpg
45822.jpg

45823.jpg
45823.jpg

45824.jpg
45824.jpg

Beside the taillights is supposed to be a mesh screen represented by decals. I will most likely use the decals as it would be quite a bit harder to cut out the openings and put in mesh.

45825.jpg
45825.jpg

45826.jpg
45826.jpg

45827.jpg
45827.jpg

Overall a nice build and the quality of the parts is quite good. This is one nice looking car. The only problem I had was that only 3 wheels touch the ground. The suspension parts are a tight fit onto their mating parts so I can see then causing the slight misalignment of parts and the wheels not all touching the ground. Knowing this now I would enlarge the opening where a pin has to go into a hole so there is not the struggle I had pushing round tabs into their respective holes. Highly recommended if you can get one.


Page:   1  2  3 

 

[ Prev ]      [ Next ]